Services

• 

  Chiller System

  • Preparation of general Assembly drawing of Chiller Equipment.
  • Detailed component drawing based on the selection of component.
  • Fabrication drawing up to the component level.
  • Ensuring proper facility for servicing of chiller (in the form of access) at the drawing board stage itself (Checking interference in the 3D layout)
  • Arriving at Bill of Material and Bill of Quantity up to the level of consumables.
  • Capable of supporting different type of refrigerant chillers (Ammonia, CFC, HFC etc.)
• 

  Air Handling Unit for Direct & Indirect Expansion along with Desiccant Dryer

  • Preparation of General Assembly drawing of Air Handling Unit
  • Detailed component drawing
  • Cooling coil with pipe joints – Depicting number of rows and tube size.
  • Filters (differentiating pre filter and HEPA filters)
  • Detailing centrifugal fans
  • Mist Separators.
  • Louvers and Dampers as per the requirement.
  • Heating coil (To control relative Humidity)
  • Arriving at Bill of material and Bill of quantity up to the level of consumables
  • Desiccant dryer (to control and maintain lower relative humidity)
• 

  Chilled Water Distribution System

  • Making General layout of piping system
  • Detailed component drawing
  • Pipeline (mentioning the type of Pipe)
  • Pipe fitting (different types)
  • Different types of Valves
  • Centrifugal pumps
  • Piping supports, based on the input about the site condition from the customer / client.
  • Insulation thickness and material
  • Supporting the customer in arriving (Based on customer Input)
  • Arriving at Bill of Material and Bill of Quantity up to the level of consumables.
  • Total head required for the system.
• 

  Air Distribution System (Chilled Air & Ventilation Air)

  • General Ducting Layout _ Based on customer input about the site condition.
  • Supporting customer in identifying (based on the input from the customer).
  • Type of Grill, Diffuser , Nozzle etc.
  • Size of Duct and reducers.
  • Insulation thickness and Material (In case of Chilled air).
  • Detailed and part drawing of ducting.
  • Type of suspension of duct.
  • Arriving at precise surface area of ducting for the project.
  • Capacity and components of AHU.
  • Arriving at BOM And BOQ up to the level of consumables.
  • Detailing of centrifugal Fans.
• 

  Rack Refrigeration System

  We provide design & development for commercial refrigeration solutions for food retail supermarkets.

  • General Ducting Layout _ Based on customer input about the site condition.
  • Supporting customer in identifying (based on the input from the customer).
  • Type of Grill, Diffuser , Nozzle etc.
  • Size of Duct and reducers.